Recently, One of our customer’s server had an issue during boot process. Below the steps on how to resolve UEFI Boot issue on Windows Server. You need to insert and boot into Windows Server Disk / ISO and open the command prompt through “Repair Windows” selection. Please be aware to take necessary precaution before attempting […]
Repair UEFI Boot Error Windows Server Read More »
Q: I got “System Error 55” when ran “net statistics server” command A. Disabling / Removing SMB1 may be caused by this issue. You can verify if SMB1 is installed or not by running the following PowerShell command. Get-WindowsFeature -Name FS-SMB1 If the issue still persist after installing/enabling SMB1, you could check troubleshooting steps from this link for your reference.
Receiving Error 55 when running net statistics server command Read More »
To troubleshoot windows computer boot problems, you need to determine in which phase the computer gets the issue. Below is the phase of the Windows Computer boots in sequence. 1. PreBoot The PC’s firmware initiates a Power-On Self Test (POST) and loads firmware settings. This pre-boot process ends when a valid system disk is detected.
Windows Computer Boot Sequence Read More »
By default, Office 365 client such as Outlook uses Exchange Autodiscover to connect to the Office 365 email account. However, in some cases you need to connect to Office 365 using IMAP or POP protocol. Below is the list of email setting for Office 365 SMTP To send emails using Office365 server enter these details:
POP, IMAP and SMTP settings for Office 365 Read More »
